How do I find the right SnapPads for my rig?Updated 11 days ago

Unfortunately, the RV industry does not have a standardized leveling system or size of jack foot. That means that different brands will have different leveling systems from year to year or from model to model. In fact, sometimes a leveling system will have different sized leveling jacks on the front and back, depending on the size or type of rig.

In addition, owners have the option of changing their jack feet for other sizes, which means previously owned RVs can sometimes have different jacks than what were put on in the factory. Through our experience we are learning which rigs typically come with which landing feet, but because of the above factors we can never be 100% sure. That's why it's important to always double check your landing system and jack foot size before ordering your SnapPads.

Most importantly, it is vital to do a full clearance check of your jacks and jack feet prior to ordering or installing SnapPads to ensure the addition of SnapPads is a safe option. Below are some important checks. Some of these are model specific.

• General Clearance Check: Standard clearance check for 2” to the side and ¾” from the top edges of the jack feet to anything in close proximity is advised for both front and rear jack feet. These pads require at least 2” of full clearance with the jacks fully retracted, airbags expanded, travel mode activated, and for dual axel Class A models. Turning the wheels fully in both directions during the clearance check is advised, as the jack assembly and placement can be close to the tires on some RVs, which can lead to SnapPads rubbing on the tires or being pulled off of the rear feet completely when in transit. The front jack feet should also be checked for proximity and position to the above crossbeam or metal crossbeam end plate under Class A or Super C models.
• Ground Clearance Check: Class C, Fifth Wheel, and Travel Trailer models could have ground clearance issues where the full retract position of the jack is closer to the ground. This could be very different from jack to jack. We recommend no less than 6-7" from the bottom of the fully retracted jack foot to the flat, even ground below. Lower lying jacks could cause SnapPads to be scraped or knocked off when navigating over areas like curbs, speed bumps, potholes, or rough roads. If navigating areas like these at speed, the suspension of the rig can force the jack feet further down into these culprits, resulting in damage or loss.

We know it’s confusing, so if you aren’t sure, please contact us and we’ll guide you to the right SnapPads for you. Simply fill out this form with as much info as you can and one of our Customer Care Agents will get right back to you with an answer. You will need to check the brand name of your leveling system, which will be marked on the control panel, measure the jack foot diameter or size, and note the shape of one or both the front AND rear landing feet, as these can be different.

For more information, you can check out our blog post on picking the right SnapPads for you. You can also contact our Customer Service Team either via email to [email protected], or via phone to 1.866.923.9538.